QUANTUM CORPORATION

ISA-151A

Data bus: 16-bit, ISA

Size: Full-length, full-height card

Hard drives supported: Two AT Interface (IDE) drives

Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB

[Image]

                                CONNECTIONS

                     Function                              Location

  34-pin control cable connector-floppy drive                CN1

  40-pin control cable connector-hard drive                  CN2

  34-pin control cable connector-floppy tape drive           CN3

  4-pin connector drive active LED                           CN9

                        USER CONFIGURABLE SETTINGS

              Function                     Location           Setting

  »   IOCHRDY signal disabled                JP1                open

      IOCHRDY signal enabled                 JP1               closed

  »   DMA request disabled            JP2/jumper 1, 2, &        open
                                              3

      DREQ 5 (DMA request)               JP2/jumper 1          closed

      DREQ 6 (DMA request)               JP2/jumper 2          closed

      DREQ 7 (DMA request)               JP2/jumper 3          closed

  »   DMA acknowledge disabled        JP3/jumper 1, 2, &        open
                                              3

      DACK 5 (DMA acknowledge)           JP3/jumper 1          closed

      DACK 6 (DMA acknowledge)           JP3/jumper 2          closed

      DACK 7 (DMA acknowledge)           JP3/jumper 3          closed

  »   DMA signal to the ATA                  JP4                open
      adaptor disabled

      DMA signal to the ATA                  JP4               closed
      adaptor enabled

  »   ATA Hard Disk mode select              JP5                open

      ATA Tape Mode select                   JP5               closed

  »   BIOS is IBM, AMI or                    JP6             pins 2 & 3
      equivalent (Polled)                                      closed

      BIOS is Phoenix (Interrupt             JP6             pins 1 & 2
      Driven)                                                  closed

  »   Factory configured - do not            JP7                open
      alter

  »   Floppy drive enabled                   JP8               closed

      Floppy drive disabled                  JP8                open

  »   Back to back I/O delay                 JP10              closed
      enabled

      Back to back I/O delay                 JP10               open
      disabled

  »   Floppy drive port address is           JP11               open
      3F0-3F7h

      Floppy drive port address is           JP11              closed
      370-377h

  »   Hard drive port address is             JP12               open
      1F0-1F7h

      Hard drive port address is             JP12              closed
      170-177h

  »   IRQ14 (hard drive interrupt            JP13            pins 2 & 3
      request)                                                 closed

      IRQ15 (hard drive interrupt            JP13            pins 1 & 2
      request)                                                 closed